V-drives with drop down tiller arm (drops down 1"). 4" X 4" rudder port flange (slotted bolt holes) and 2" O.D. port. This rudder will have RTPL cast on it and is 14" long. There is a RTPN casting that is only 12.50" long. This can replace it if there is enough room to the trailer guard.
"MARINE HARDWARE" RUDDER RENEW KIT Fits 1998 UP Marine Hardware Rudders Only. Marine Hardware rudders will usually be stamped MH as the first 2 digits of the part number on the rudder. Will not fit older style Marine Hardware rudders that have a nylon bushing at the top and bottom. Seal is 1" I.D. and 1-33/64" O.D. fits 1" rudder post.
Fits SEF (South Eastern Foundries) 1010-1 rudder port. Includes 2 lip seals, 2 O-rings, 1 snap ring, 1 plastic bushing, 2 set screws and 1 zerk. Seal has #11060 on it and measures 1-1/2" O.D. and 1-1/8 I.D.
Replacement seal for GLIDE GMSS and OJ dripless systems with 1-1/8" shafts. Also fits OJ rudder ports original equipment on Mastercrafts 2003 thru 2012. Does not fit the GMSS shaft seals that have 6 screws on the end cap.
For thru-hull fittings above and below the water line (3 oz tube).
* Watertight bonding/sealing of fiberglass and wood.
* Ideal for thru-hull and deck fittings, and deck to hull joints.
* Flexible, fully cures in 24 hours.