Engine

CRANK SENSOR 5.0/5.7 MPI R020038

PCM 2002 UP 5.7/5.0 MPI, FITS INTO TIMING COVER. NOT FOR LT1/LTR OR 6.0L. Indmar MCX and 2006 and up Indmar 5.7L engines with HVS (flat cap) distributor. Indmar part number 556293. Bin Number (ISBN): 91511

MAP SENSOR GM TBI SOME MPI R020017

GM Throttle Body Injection Manifold Absolute Pressure sensor 94 and up. Also used on PCM Pro Tec Injection (BARO) and (MAP). Also fits Indmar LT1 and Monsoon 1 (96-97) Pt # 556006. Bin Number (ISBN): 81310

IDLE AIR CONTROLLER TBI

Throttle Body Injection IAC, GM 94 and up. Indmar old PT # 55-6085 now superceeded by S556094. Also fits Indmar LT1 Corvette. Bin Number (ISBN): 81210

ADAPTER, FLAT RSPNS KNOCK SENSOR

Adapter for the Flat Response Knock sensor. Indmar 2006 (original brass) up 5.7L and PCM 2008 up 5.7L, 5.0L. Engines with this style sensor will have one on each side of the block located in the block drain. Bin Number (ISBN): 92914  

Sensor, Knock (Flat Response)

PCM usually 2008 & UP, GM 5.0L, 5.7L & 6.0L. There are some exceptions where the old style knock sensor has been used on both sides of the block (Item # 1249) after 2008. Bin Number (ISBN): 110312

SPARK PLUG WIRE SET GT-40 EFI

PCM 351 GT40 MPI EFI, Original Equipment.  Manufacturers' choice for premium performance. Suppression Core marine 8mm silicon wire sets. Includes coil wire. The OEM red wires are no longer available and the color currently being used by PCM is gray...

STARTER KIT, BOTTOM MOUNT GM 5.7

Arco Marine Starter Bottom Mount GM PCM Indmar RF122015: Fits: PCM, Indmar, Mercruiser. 5.7, 5.0, 7.4, 305, 350, 454. This kit includes new mounting bolts and metric nuts. CE Certified and in compliance with: USCG Title33 CFR 183.41, SAE J1171, ISO 8846...

STARTER MOTOR BOTTOM MOUNT 6.0L

2003+ 6.0L, ZR6, ZR409, LY6, ASSAULT 6.0L. Bin Number (ISBN): 20608

STARTER LH GM TOP/REAR PCM 5.7, 6.0, 6.2

Left Hand Flywheel rotation "Standard" Engine Rotation, Permanent Magnent top mount (rear entry) starter. Fits into bellhousing above and to the side of the transmission. Fits 5.0L, 5.7L, 7.4L H5 & H6 PCM, Indmar PT# 573001, Some Mercruiser. Replaces...

MARINE TOP MOUNT STARTER RH - CHEVY 305/350/454

Right Hand "Opposite" Engine Rotation, top mount bolts into Bellhousing (rear entry)Most Correct Craft With 454 PCM RA122008. CHEVROLET MARINE STARTERS Caution! Not all starters are Coast Guard approved. These marine starters have the correct bushings...

STARTER KIT, RH, REVERSE ROTATION, PERMANENT MAGNET

FORD 351 STARTER (RH) Fits "New" right-hand engine rotation Ford permanent magnet starter. Fits most Correct Craft thru 1988 and a few up to 1994 with 1:1 transmission. PCM model number will begin with PRD or PRP. Look at pictures for wiring...

ARCO MARINE STARTER KIT LH FORD 351, 302 PCM & INDMAR

Left Hand "Standard" Engine Rotation 2 bolt. New style permanent magnet starter replaces old plunger style. Most PCM and Indmar Fords in Mastercraft (a few in late 70's were right hand), Supra, Moomba, 89 up Nautique with 1.23 trans., Centurion, Supreme,...

PIGTAIL, 12" MALE TO FEMALE

One foot harness extension, 8 prong rectangular male to 8 prong rectangular female. Can be cut in half and spliced to make a new connection for the engine to boat harness. Bin Number (ISBN): 92713  

COVER ELECTRICAL PANEL

ELECTRIC BRACKET COVER R126007A PCM FORD CARBURETED ENGINES, THIS PLASTIC COVER GOES OVER THE STARTER RELAY, CIRCUIT BREAKER ETC. CURRENT COVER IS BLANK WITH NO EMBOSSED PCM LOGO'S.   Bin Number (ISBN): 112411  

WIRE HARNESS, FORD CARB

FORD ELECTRONIC IGNITION WIRE HARNESS R121025A PCM Carb FORD 87 ON (No Resistor Wires)Can be used on 87 and prior with ballast resistor but you will need to finish the conection to the coil. This harness is not designed for use with an alternator...